How to install landscape tile (rewrite to unique content)

Most of the home owners use tile on their home to increase the interior beauty of their home. A good quality tile plays a vital role in giving you the peace of mind for years after.  But it is not only the quality of the tile that matters but also the way of installing them on your place is another important issue. The landscape tiles are for installation on walls. These tile are highly durable and resistant to water. Still it is preferred that you install them for dry areas and avoid wet areas like kitchen and bathroom. The installation process of landscape tiles is easy and you can install all by yourself following this guide.

Installation procedures of Fan pattern (loose)

The process of beginning with every tile installation is same; first you need to clean the area properly where you want to install the tiles. Clean the sub floor from any foreign material and make the surface flat. If the surface is not flat you need to do plastering to make the surface flat, let the surface dry completely before you proceed. Draw a straight line XY from the midpoint and similar lines making gap of 90 cm from each side.  Now it is time to draw a horizontal line and name them UV from that same midpoint and create similar line of gap of 45cm from both upper side and lower side of the measurement.  

Now draw a radius of 90cm above the previously measured lines. Start the circle from the point where XY and UV crossed each other. Draw this same pattern of circle on the whole areas where you want to install the tile. Use any sticking tool and use a hard nail with a starting point of 35” towards and proceed with the lines you have created.  Keep the landscaped tiles drowned in water. Mix the adhesive cement with water properly and let the mixture settle for 5minutes to let the mixture gets chemically combined completely. Now start with the outermost side of you planned floor and gradually move to the center. Make sure you have adjusted the tiles properly and installed them well while you complete the pattern. Now cleaning the excessive adhesive from the surface of the tile and clean the whole area of the tile with a wet sponge. Let them dry and install properly before you start grout line on them. And now it is all set and your home is glowing more than ever before.

Installation procedures of Circle Pattern

First calculate the diameter of you radius. Draw a straight line XY and a horizontal line UV from the midpoint of the area. And then start the circle with that radius from the midpoint of your area. Draw your radius at the point where XY and UV intersected.  Now mix the adhesive cement with water and start installing the tile from the midpoint of the circle that you have drawn. And install them as you have drawn and let them dry for 24 hours. Clean the surface of the tile using a wet sponge and grout the lines when they are completely dry.

Installation methods for a wall corner

This is an important part while you install tile on your wall. You can do this with any of these methods. First you can use a Vcap tile which has a joint of 1cm. secondly you can use 2’X8” tile to install and adjust them properly at the joint of the corner. Third method is you can cut one side of the tile at 45 degrees and out the separated tile together to fit in the corner of the wall.